Application Overview
Small household appliances and kitchen machines (blenders, coffee makers, rice cookers, air fryers, toasters) use ABS or PC/ABS housings that must meet local flame-retardant and food-contact safety rules. Switching from raw Sb2O3 powder to a pre-dispersed masterbatch solves three recurring production issues: white specks / plate-out on glossy panels, dusting and metering drift in the dosing hopper, and lot-to-lot whiteness & flame-retardancy variation.
Carrier & Compatibility
- Host resin: ABS or PC/ABS alloy. Select an ABS/SAN carrier whose MFI is within ±10–15% of the base resin to avoid short-shot, weld-line weakness or dispersion streaks.
- For PC/ABS, use a carrier that tolerates both melt windows (ABS at ~220–240 °C and PC at ~270–290 °C) without premature degradation.
- Verify carrier MFI and polarity on the CoA so the masterbatch flows like the base polymer.
Dosing & Halogen–Antimony Ratio
- Use effective Sb2O3 3–5 phr (2.5–4 wt%) on the polymer fraction; take the lower end for thin-wall (1.0–1.5 mm) housings to preserve impact and surface gloss.
- Match the bromine source with Br:Sb ≈ 3:1 calculated on effective bromine (not compound weight) — e.g. brominated epoxy / brominated polystyrene oligomers used in ABS. For PC/ABS, verify the bromine source tolerates the higher PC melt window.
- Where low smoke or anti-drip is required, add zinc borate 30–50% of the Sb2O3 level as a smoke suppressant (optional).
Processing Precautions
- Pre-dry the masterbatch and host resin: 2–4 h at 80–90 °C for ABS, and keep PC/ABS resin moisture <0.02% to prevent hydrolysis-induced silver streaks.
- Keep melt temperature ≤ 220 °C (ABS) to avoid yellowing; for PC/ABS respect both windows and do not exceed ~270–290 °C on the PC side.
- Monitor screen-pack pressure rise / die or mold fouling during the trial to detect dispersion or plate-out issues early.
- A fine-grade D50 0.8–1.5 µm minimizes white specks and surface bloom on glossy or colored panels.
End-Product Qualification
- Verify UL94 V-0/V-1 at the actual housing wall thickness (1.0–3.0 mm), not on thick plaques.
- Impact retention ≥ 85% vs. non-flame-retardant reference; check cold crack at −20 °C and heat aging 85–105 °C with no surface exudation.
- For kitchen machines, screen heavy-metal migration (Pb, Sb, Cd, Cr) against food-contact limits where applicable.
Supplier CoA Verification
- Purity ≥99.5%, moisture <0.3%, Pb <50 ppm, Fe <100 ppm, D50 0.8–1.5 µm, whiteness ΔE <1 versus reference, plus a declared carrier MFI.
- Keep 200 g per-lot retained sample for 12 months; link batch number ↔ CoA ↔ retained sample ↔ molding trial for ≥5 years.
- Require annual re-qualification; any change of carrier resin must be re-certified, never changed unilaterally.