服务热线
18971017202
For buyers of unsaturated polyester resin systems (FRP panels, SMC/BMC, gelcoat-backed laminates), antimony trioxide is rarely chosen on purity alone. The real deciding factor is the cure window — and Sb2O3 interacts with that window in three ways most spec sheets never mention.
It shortens the window, gently. Sb2O3 is nearly inert toward free-radical curing, but its associated lead and iron traces are not. At 99.5% purity with Pb ≤ 0.1%, the gel-time shift is typically under 5%; at lower grades it can reach 10–15%. If your workshop runs a narrow MEKP/cobalt window, ask for the supplier's actual gel-time shift data at 3 phr loading — not just a CoA purity line.
Particle沉降 vs. cure. In low-viscosity, hand lay-up resins, coarse Sb2O3 (D50 > 2 µm) settles before gelation, leaving the top ply under-framed. Masterbatch or wet-dispersed grades resist settling far better; if you buy powder, disperse it into the resin the same day and do not predispersive stock it.
Heat build-up in thick sections. FRP parts above 8 mm exotherm hard; Sb2O3 raises filler loading and slightly increases peak exotherm. For thick laminates, pair Sb2O3 with a smoke suppressant or shift part of the loading to a zinc borate synergy — you gain LOI without pushing peak exotherm past the resin's ceiling.
Practical buying notes: ask the supplier for D50 and D97 on each lot, not just an average; confirm whether the grade is "catalyst-grade" (low Pb) or "flame-retardant-grade" (cost-optimized) — the two are sold under similar names. For FRP buyers, the correct question is not "how pure is your Sb2O3" but "what does it do to my gel time at my loading" — suppliers who can answer that with data are the ones worth contracting long-term.