Feeding antimony trioxide masterbatch through gravimetric feeders is more forgiving than feeding powder, but only if the feeder is calibrated to the pellet's actual bulk density and slip behavior.
Feeder setup checklist
- Calibrate using the masterbatch's true bulk density, not the supplier's nominal figure.
- Run a 10-minute tare check; pellet dust buildup on weighing cells is the top cause of drift on older twin-screw lines.
- Use a wide throat; narrow throats promote pellet bridging, which shows up as short-term screw-speed spikes.
Process verification steps
- Sample the extrudate every 15 minutes during the first hour and test flame-retardant spread, not just visible dispersion.
- Record feeder loss-in-weight versus actual masterbatch consumed per shift; a gap above 2% indicates dosing error.
- Recheck after product changeovers — screw speed and melt temperature shifts alter apparent flow.
Common mistakes (and their cost)
- Assuming powder-based calibration still applies. Errors of 5-10% in Sb2O3 loading happen silently.
- Blending masterbatch pellets with PP regrind of different geometry; bridging returns at high throughput.
- Skipping hopper-level records during night shifts; under-feed is typically caught only at final fire testing.
Recommended audit cadence
Monthly: full gravimetric check. Quarterly: weigh all feeder output versus actual Sb2O3 consumed across the plant. Yearly: repeat supplier-supplied baseline measurements with your own scales.