服务热线
18971017202
Consistent flame-retardant performance in Sb2O3-masterbatch lines depends less on the recipe and more on how accurately the masterbatch is metered into the extruder. Underfeeding drops the bromine-to-antimony synergy below the effective window and shows up as failing UL94 lots; overfeeding wastes cost and raises haze or impact-strength penalties.
Volumetric vs gravimetric feeders. Volumetric auger feeders are inexpensive but output varies with bulk-density drift, which masterbatches are prone to after transport settling. For let-down ratios above roughly 5% and for regulated end-uses, gravimetric (loss-in-weight) feeders are the safer choice; they hold dosing error typically within +/-1% versus +/-3-5% for volumetric units.
Premixing and let-down control. Where only a volumetric feeder is available, weight-check the first 10-20 minutes of each batch run: collect extrudate samples and confirm actual masterbatch content against the target let-down ratio. Correct the feeder speed rather than trusting the dial setting.
Masterbatch carrier match. Match the carrier resin to the processed polymer (PP carrier for PP, PE carrier for PE/LLDPE) to avoid gels and dispersion streaks. Verify the supplier's stated active Sb2O3 loading on the batch certificate of analysis, and keep records linking batch number to feeder settings for traceability.
QC checkpoints to write into the SOP: (1) incoming CoA verification of active content per batch; (2) feeder calibration schedule (weekly for volumetric, monthly verification for gravimetric); (3) ash or ICP check on finished compound every shift when dosing a new batch; (4) documented correction of any feeder drift.
Suppliers who can state feeder-side recommendations - not just resin-side ones - generally have real compounding field experience; ask for case references when qualifying a masterbatch source.