服务热线
18971017202
Flexible PVC remains the largest conduit for antimony trioxide in wire and cable, but insulation and sheathing layers call for different treatment than rigid profiles. Buyers comparing Sb2O3 masterbatch grades for PVC compounds should focus on three practical questions.
1. Split the dosage by layer, not by compound. Insulation layers typically run at lower filler loading to preserve dielectric properties, while outer sheaths tolerate higher antimony loadings for flame spread control. A supplier quoting a single "recommended dosage" for the whole cable build is a red flag; request per-layer ranges validated with the actual plasticizer system in use.
2. Plasticizer migration changes everything. High-solvent plasticizer systems (DOP-class) can carry antimony particles toward the surface over time, causing whitening and uneven flame performance at the surface. Masterbatches with pre-wetted carriers and tighter particle encapsulation resist this; ask whether the grade has surface-migration test data (e.g., after 7-day aging at 70°C), not just initial dispersion figures.
3. Verify these supplier items before contracting: - Particle size distribution (D50 and D97), since coarse particles raise spark-test failures in thin insulation - Volatile content and moisture specification, relevant to porosity in extruded insulation - Whether the carrier resin matches the PVC blending system (CPE vs PVC-carrier masterbatches behave differently in two-roll and calendar processes) - Batch-to-batch white-degree consistency if the compound feeds a colored sheath line where color shifts are visible
For buyers sourcing both Sb2O3 powder and masterbatch for one cable plant, aligning these specifications across the two supply streams — with a clause allowing re-test on arrival — is cheaper than debugging flame failures after cable qualification.