服务热线
18971017202
Transparent and semi-transparent PVC film applications—pharmacy blister packaging, food wraps, and laminating films—demand an unusual balance: good flame retardance and smoke suppression with minimal impact on optical clarity. Antimony trioxide (Sb2O3) is the key synergist added with brominated or chlorinated FRs, but in transparent PVC the form in which it is added matters enormously.
Sb2O3 masterbatch for transparent PVC uses a carrier resin with refractive index closely matched to PVC resin. The masterbatch pellets disperse the active trioxide into primary particles below 1 µm, avoiding agglomerates that scatter light and introduce haze. Typical loading in the masterbatch runs 60–70%, with addition rates to the compound between 2 and 6 phr depending on the halogen partner and target flame rating.
Dispersion is the controlling variable. Even well-formulated trioxide becomes a haze defect if agglomerates exceed roughly 1 µm in a transparent film. Masterbatch producers control this through carrier selection (grafted, low-molecular-weight carriers for thin-gauge film), melt filtration, and controlled cooling in pelletizing.
Adding dry Sb2O3 directly to the mixer in high-transparency film work risks: - Agglomerate formation where powder meets plasticizer; agglomerates persist through calendering and appear as visible specks and haze. - Inconsistent optical properties across the roll width. - In Calendering lines, poor powder wet-out also raises the plate-out risk on calender bowls.
For thin film, powder addition only works with intensive premixing (high-shear) and filtration-free calendering, so most film producers prefer masterbatch.
For transparent and high-clarity PVC films, use a finely dispersive Sb2O3 masterbatch matched to the PVC carrier; for opaque sheet and profiles where optical transparency is irrelevant, powder may be the more economical route. Verify every delivery by CoA parameters and a film trial, not by grade name alone.