服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for HIPS Refrigerator Liners & Appliance Housings

发布日期:2026-11-21 05:35:37   浏览量:0

Why masterbatch over powder

High-impact polystyrene (HIPS) refrigerator liners and appliance housings need flame-retarded grades that hold a tight UL94 V-0 at thin walls while keeping impact and surface finish. Direct Sb2O3 powder dosing causes dusting, poor lot-to-lot dispersion, and white specks that show up on glossy cabinet skins. A masterbatch delivers clean, reproducible dosing and even dispersion.

Carrier and ratio

  • Use a styrenic carrier (HIPS/PS) with MFI matched within 10–15% of the letdown resin to avoid flow mismatch and short-shot.
  • Effective Sb2O3 dose 3–5 wt% on the polymer fraction; tune the halogen:antimony ratio to ≈3:1 molar on effective bromine (from brominated epoxy oligomer / DBDPE / TBBPA), not on compound weight.
  • Keep melt window 200–240°C; brominated synergists decompose above ~300°C — watch residence time.

Key checks on the line

  • Impact retention: track Izod/Charpy drop vs unfilled base; reject if >10–15% loss.
  • Surface finish: glossy liner skin is prone to white specks and mould-fouling — trial first on a cavity, schedule mould cleaning around plate-out.
  • Haze/whiteness: use fine grade D50 0.8–1.5 µm to limit visible bloom.
  • Thermal aging: refrigerator liners see 85–105°C; verify ΔE and impact retention after 1000 h.

CoA verification per lot

Purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm, Pb <50 ppm, Fe <100 ppm, whiteness ΔE <1. Require UL94 V-0 on the final liner/housing wall thickness (not on pellets), and keep a 200 g per-lot retained sample for 12 months plus annual requalification.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们