服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Epoxy-Polyester Hybrid & TGIC Powder Coatings

发布日期:2026-11-21 05:35:49   浏览量:0

Application context: Thermoset powder coatings (epoxy-polyester hybrids, TGIC-polyester, pure epoxy) for flame-retardant appliance enclosures, cable trays and ductwork. Antimony trioxide masterbatch replaces loose powder dosing on the premix line.

Masterbatch over powder — why

  • Dust-free / EHS: Loose Sb2O3 powder is a respiratory hazard and contaminates the mix room; masterbatch locks it into a resin carrier pellet.
  • Charge & transfer efficiency: Powder coatings rely on electrostatic charging — uniform Sb2O3 dispersion avoids local charge-leakage hot spots and keeps first-pass transfer yield stable.
  • Lot consistency: Pre-dispersed masterbatch eliminates per-batch weigh/weigh variation seen with powder sifting.

Carrier & dosing guidance

  • Use a saturated-polyester / epoxy-compatible carrier (low-melt flow, chemically neutral); avoid plasticizer or additive carriers that bleed into the powder matrix and shift gel time.
  • Effective Sb2O3 dose: 3–5 wt% on the total powder formulation, coordinated with a halogen source (e.g. brominated epoxy / chlorinated paraffin) at ~3:1 halogen:Sb on effective halogen.
  • Gel-time shift red line: measure gel time / bake-cure window on a trial plaque; a drift >10–15% from the unmodified powder is a rejection line — indicates carrier interaction with the curing system.

Particle & processing checks

  • Fine grade D50 0.8–1.5 µm for thin-film (60–120 µm) coatings — coarse Sb2O3 shows as orange-peel roughness and pin-holes.
  • Settling stability: pre-dispersion must hold ≥6 months in storage; check for hard sediment before line use (re-disperse gently, do not exceed rated shear).
  • Sieve/mesh check: run the finished powder through the coating plant sieve; any residual coarse Sb2O3 agglomerates cause surface defects and poor film integrity.
  • Cure window: verify gel time, ΔE color drift and gloss retention across the full oven band; Sb2O3 can raise opacity/whiteness in dark shades — adjust pigment loading.

Final-product fire & QC

  • Confirm reaction-to-fire on the cured film / finished part, not the raw powder: UL94 / EN 13501-1 vertical-burn on coated panels at target film thickness.
  • Per-lot checks: gloss (60°), ΔE vs standard, adhesion (cross-cut), impact resistance, and gel-time consistency.

CoA verification (per supplier lot)

Purity ≥99.5% | Moisture <0.3% | D50 0.8–1.5 µm | Pb <50 ppm | Fe <100 ppm | Whiteness ΔE <1 vs standard.

Discipline

  • Keep a 200 g per-lot retained sample for 12 months; record CoA batch ↔ masterbatch lot ↔ coating lot mapping for traceability.
  • Annual requalification of the masterbatch against the incumbent powder formulation; re-trial on gel time and fire rating whenever the halogen source changes.

For buyers / formulators: verify supplier's CoA and run a small-scale gel-time + fire trial before batch commitment. Parameters must match the manufacturer's actual certificate of analysis.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们