服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Automotive & Industrial Rubber Coolant/Air Hoses

发布日期:2026-11-21 05:35:50   浏览量:0

1. Application context

Flame-retardant EPDM/CR/NBR rubber hoses (engine coolant, heater, air, hydraulic return) must meet UL94 / FMVSS 302 / ISO 6722 and OEM burn requirements while surviving flex, heat aging and fluid contact. Sb2O3 is added as a halogen-antimony synergist, almost always via masterbatch for clean metering and even dispersion in the dense rubber matrix.

2. Masterbatch-over-powder advantage

  • Cleaner dosing on batch mixing lines; avoids weigh-error and airborne dust in the compound room.
  • Pre-dispersed carrier (EPDM/EVA/CR-based masterbatch) shortens the mix cycle and improves filler distribution — critical where antimony must reach 3–6 phr uniformly through the hose wall.
  • Consistent lot-to-lot active content beats raw-powder weigh tolerance.

3. Dose & halogen-antimony ratio

  • Effective Sb2O3: 3–6 phr (rubber phr basis), tuned to the halogen source.
  • ~3:1 halogen:Sb on effective halogen weight. With chlorinated paraffin (CP-52/70) use Cl:Sb ≈ 3:1; with brominated systems (DBDPE, TBBPA) retune Br:Sb ≈ 3:1 on effective bromine — not on compound weight.
  • Zinc borate 3–8 phr may be co-added for smoke suppression where hose burn is a rating concern.

4. Dispersion & processing checks

  • Two-roll mill dispersion check and Mooney viscosity (ML 1+4) within ±15% of specification.
  • Watch bloom/surface exudation on black EPDM hoses — prefer fine-grade D50 0.8–1.5 µm to limit surface dusting, especially in hot-service hoses.
  • Peroxide/sulfur cure interference: confirm t90 shift stays within 10–15% rejection red line when Sb2O3 masterbatch is added.

5. End-product qualification (on cured hose, not raw compound)

  • LOI and vertical burn (UL94 / FMVSS 302 / ISO 6722) on finished hose wall.
  • 22h/70°C compression set red line ≤10%; heat aging 135°C/168h with tensile/elongation retention <10% drop.
  • Cold flex −20°C; fluid-resistance soak (coolant/glycol) for wall swell within spec.

6. CoA checks & retained sample

  • Purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm, Pb<50 ppm, Fe<100 ppm, whiteness ΔE<1 per lot.
  • 200 g per-lot retained sample, 12 months; annual requalification.
  • Bind CoA lot number ↔ test report ↔ retained sample for ≥5 years traceability.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们