服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Silicone Rubber Cable & Appliance Wiring Insulation

发布日期:2026-11-21 05:36:04   浏览量:0

1. Application context

Silicone rubber (VMQ/HTV) wires and appliance cables need flame retardancy without sacrificing dielectric stability, heat aging or flexibility. Sb2O3 as a masterbatch — rather than loose powder — is the preferred compounding route: it removes dust, fixes the dose per batch, and keeps the fine particle grade dispersed uniformly so the cured rubber surface stays clean and free of white bloom.

2. Key technical points

  • Carrier compatibility: use a silicone-compatible carrier (low-volatility vinyl/silicone base or a high-purity EVA matched to the rubber's polarity). Do NOT use a generic plastic carrier that migrates or interferes with the platinum/peroxide cure.
  • Dose window: effective Sb2O3 at 3–5 phr is the practical range; retune the halogen:antimony ratio to ≈3:1 on the actual halogen source (brominated polydimethylsiloxane or chlorinated paraffin CP-52/70) selected for the formulation.
  • Fine grade: D50 0.8–1.5 µm to avoid white specks/bloom on the finished wire surface and to keep dielectric tracking clean.
  • Cure-interference check: run an MDR t90 comparison between the masterbatch batch and the control compound — reject if cure shift exceeds 10–15%, since some carriers or residual acidity can inhibit platinum cure.

3. Process & QC checklist

  • Pre-dry: 2–4 h at 70–80 °C when storage RH > 60%, to prevent moisture from degrading dielectric performance.
  • Dispersion: two-roll mill / internal mixer dispersion check plus filter-pressure proxy before extrusion; look for consistent colour and no agglomerates.
  • End-product verification per lot: LOI / vertical burn on cured plaques (UL94 V-0 or FMVSS 302), dielectric strength, volume resistivity, and 7-day water-immersion insulation resistance; cold-bend at −20 °C and heat aging at 200 °C/168 h with retention drop < 10%.

4. Supplier CoA qualification

  • Purity ≥ 99.5%, moisture < 0.3%, Pb < 50 ppm, Fe < 100 ppm, D50 0.8–1.5 µm, whiteness ΔE < 1.
  • Retain 200 g per lot for 12 months; CoA batch number ↔ test report ↔ retained sample traceability for ≥ 5 years.
  • Annual requalification and line-trial qualification on the actual cable line before batch commitment.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们