服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for FR-PBT / FR-PET Electrical Connectors & Relay Housings

发布日期:2026-11-21 05:36:12   浏览量:0
  1. Masterbatch-over-powder decision: avoids white specking at high shear, cut the 10-15% dose needed for same UL94 rating vs raw powder, and gives per-lot dosing consistency on critical thin-wall (0.4-0.8mm) automotive/electronic housings.

  2. Carrier matching: use PBT/PET IV-compatible carrier (0.8-1.0 dL/g) or a low-MFI blend so the masterbatch disperses before degradation; MFI of masterbatch within ±10-15% of the let-down resin to avoid short-shot and flow marks.

  3. Dosing & synergy: effective Sb2O3 3-5 wt% on polymer fraction, Br:Sb ≈ 3:1 molar calculated on EFFECTIVE bromine from brominated epoxy oligomers / DBDPE (not compound weight). For PBT keep melt ≤260-265°C; PET ≤270°C to limit hydrolysis and die deposit.

  4. Pre-drying: PBT/PET are hydrolysis-sensitive — pre-dry 4-6h at 120-130°C to moisture <0.02% (PET <0.005%) before dosing; moisture above this drops tensile strength and promotes splay/silver streaks on connectors.

  5. Process watch: monitor hopper feeding stability (masterbatch must flow in gravimetric feeders), screen-pack pressure rise as dispersion proxy, and mould-plate-out schedule at 260°C+.

  6. End-product QC per lot: UL94 V-0/V-1 at final wall thickness (0.4-0.8mm), CTI ≥600V for relay/connector creepage, heat aging 150°C/1000h with tensile retention ≥85%, -40°C cold-crack, and dimensional stability on press-fit pins.

  7. CoA acceptance: purity ≥99.5%, moisture <0.3%, D50 0.8-1.5µm, Pb<50ppm, Fe<100ppm, whiteness ΔE<1; retain 200g per lot 12 months; batch↔CoA↔finished-part traceability ≥5 years with annual re-qualification and line-trial before batch commit.

  8. Compliance note: verify the finished connector/relay meets the specified standard version (IEC 60335-1 / UL 94 / LV 214) at final wall — never certify on thick plaques only.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们