服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 masterbatch dosage and selection for EVA/POE photovoltaic encapsulant and flame-retardant film compounds

发布日期:2026-11-21 05:34:09   浏览量:0

Why film-grade flame retardancy differs

EVA and POE encapsulant and film compounds run at high output rates on twin-screw lines, and any coarse particle or poor dispersion becomes a gel point or optical defect. Antimony trioxide selection for these grades must balance flame performance, transparency, and long-term reliability.

Dosage and formulation benchmarks

  • Typical Sb2O3 loadings in halogenated film compounds: 2–4 phr paired with 4–8 phr halogen synergist
  • Above 5 phr Sb2O3, haze rises noticeably; film optical grades should cap loading and compensate with brominated co-synergists
  • Masterbatch carrier: use EVA (VA 28% or matching base resin) rather than LLDPE carriers to keep compatibility and prevent migration

Purity and particle size requirements

  • Sb2O3 assay ≥ 99.5%; Pb ≤ 0.05% for encapsulant grades to avoid ionic contamination
  • Particle size D50 ≤ 1.0 µm and narrow distribution; coarse tails cause micro-haze and die-line defects in thin films
  • Low dust masterbatch form (60–80% Sb2O3 in carrier) simplifies gravimetric dosing at 3–5% letdown

Processing and reliability checks

  • Keep compounding temperatures below 200 °C and limit residence time; over-shearing high-load masterbatch degrades dispersion
  • Require per-lot COA with assay, particle size (D50/D98), and volatiles; batch-to-batch D50 drift over 0.2 µm should trigger rejection
  • Run pilot film trials measuring haze, LOI, and damp-heat aging (1000 h, 85 °C/85% RH) before qualifying a supplier lot

Procurement guidance

Qualify two suppliers in parallel with identical pilot trials, compare measured LOI and haze rather than datasheet claims, and negotiate volume-linked pricing tied to published antimony indices with quarterly review clauses.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们