服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch vs Powder in Thin-Film Extrusion: Selection Guide for PP/PE Film Producers

发布日期:2026-11-21 05:34:18   浏览量:0

For biaxially oriented PP (BOPP) and cast PE film lines, the choice between an antimony trioxide (Sb2O3) masterbatch and a neat powder blend directly affects flame-retardant consistency, film clarity, and line uptime.

Why masterbatches suit film extrusion

  • Dispersion at the carrier level: pre-dispersed Sb2O3 in a polyolefin carrier eliminates the dry-blend segregation that causes pinhole flame-test failures on thin gauges (below 50 µm).
  • Feeding accuracy: gravimetric dosing of pellets is more repeatable than powder volumetric feeders, keeping LOI and UL94 results within spec roll-to-roll.
  • Housekeeping: pellet handling avoids dusty powder around the die, reducing contamination of chill rolls and optical defects.

When neat powder still wins

  • Very high loadings (above roughly 8–10% Sb2O3 in the final film) are easier to hit by powder let-down without excessive carrier content.
  • Compounding in-house with a twin-screw gives a fully bound dispersion; film lines feeding powder to a mixer should verify scatter of antimony content by XRF per batch.

Practical checks before purchase

  1. Request a masterbatch TDS with carrier MFI matched to your film resin.
  2. Ask for the particle-size distribution (D98 typically at or below 3 µm for thin film to avoid die-screen blockage).
  3. Pilot one roll at minimum gauge and run vertical burn tests on both film edges.

Bottom line: for thin, optical-grade flame-retardant film, a well-dispersed Sb2O3 masterbatch usually delivers fewer flame-test rejects; reserve powder blends for thick gauges or compounding in-house.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们