Product focus: Antimony trioxide (Sb2O3) flame-retardant masterbatch for polyamide and glass-filled PA66 compounds.
Why Sb2O3 Matters in PA Flame Retardancy
Polyamide (PA6/PA66) requires a halogen co-agent — typically decabromodiphenyl ethane or brominated polystyrene — to reach UL94 V-0 at 1.6 mm. Antimony trioxide acts as the synergist that converts the halogen into volatile antimony halides in the flame zone, roughly halving the bromine loading needed. A typical PA66-GF30 V-0 formulation uses 12–14% bromine source with 4–6% Sb2O3.
Practical Selection Points
- Use masterbatch, not powder, for PA. PA processing temperatures (260–285℃) sit close to the melting range of PA66 itself; dusty Sb2O3 powder can disperse poorly and settle in screw channels. The masterbatch carrier (PE or PA-compatible) meters cleanly and disperses within 3–5 screw revolutions.
- Check moisture before molding. Both PA and Sb2O3 masterbatch must be dried to <0.1% moisture; otherwise hydrolysis-driven molecular weight loss shows up as brittleness, not as a flame-retardant failure — which makes it easy to misdiagnose.
- Beware of glass-fiber competition. In GF-reinforced grades, pigment and filler loading compete with Sb2O3 for the halogen synergy. Raise Sb2O3 by 0.5–1% rather than the bromine source to keep cost flat.
- Electrical grades. For connectors, ask for low-lead, low-iron masterbatch; ionic impurities degrade CTI tracking performance.
Quality Verification
Request per-lot CoA with Assay (≥99.5% Sb2O3), particle size D50 ≤ 1.5 µm, and whitennes (L* ≥ 95). For critical connector parts insist on the CTI test at the compounder, not merely at the resin stage.
Contact
Hubei Zhongti New Material supplies Sb2O3 masterbatch with PA-compatible carriers and full CoA documentation. Sample lots of 25 kg available for molding trials.