服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Antimony Trioxide for Wires, Cables and Flexible Insulation: Grade and Dosage Guide

发布日期:2026-11-21 05:34:26   浏览量:0

For compounders of wire and cable insulation and sheathing, antimony trioxide (Sb2O3) remains the default synergist for brominated flame retardant systems. Getting the grade and loading right balances flame performance against insulation resistance and elongation at break.

The halogen-antimony synergy window

Sb2O3 works by volatilizing with the halogen source to form antimony halides and oxyhalides that quench flame radicals in the gas phase. The classic benchmark ratio is 3:1 halogen to antimony by weight — for example, 15 phr bromine with 5 phr Sb2O3 in a PVC sheath or an EVA-based HFFR-adjacent system. For cable compounds you typically stay within a 2.5:1 to 3.5:1 window; going below 2:1 wastes halogen, going above 4:1 adds cost and ash without measurable LOI gains.

Choosing the right grade for flexible insulation

  • Fine particle size (0.8–1.5 µm) improves dispersion and lets you hold the same LOI at lower loading — relevant for thin-wall insulation where every percentage of additive competes with filler-free flexibility.
  • Low-lead, low-iron grades (high-purity 99.5%+) matter for halogen-free-adjacent low-smoke compounds and for insulation resistance retention in wet aging tests.
  • Surface-treated grades (with silanes or stearates) reduce moisture pickup and improve dielectric performance in humid environments — worth specifying for outdoor cables.

Practical dosage starting points

Compound type Typical Sb2O3 phr
Flexible PVC insulation 4–7
Flexible PVC sheathing 6–10
EVA/XLPE low-smoke sheath 3–6
TPE/TPO jackets 3–5

Watch-outs for cable applications

Water absorption is the most common failure mode: uncoated Sb2O3 modestly raises moisture uptake, which can pull down insulation resistance after hot-water immersion testing. Use treated grades and validate against the relevant IEC/UL immersion requirement. Also check elongation at break after dry and wet thermal aging — over-compounding with synergy filler is the usual cause of brittle aged samples.

Supplier verification checklist

Before signing off a Sb2O3 lot for cable production: confirm CoA values for Sb2O3 ≥ 99.5% (or the grade's specified purity), lead and iron limits within spec, particle size distribution (D50 report), and white grade color consistency for pigmented compounds. Run a pilot compound at the target loading to confirm LOI, smoke density (EN 50268-2 or equivalent) and aged mechanical properties before final purchase orders.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们