服务热线:
18971017202
您的位置:首页 >> 新闻中心

Antimony trioxide masterbatch in engineering plastics: dosing and dispersion control

发布日期:2026-11-21 05:34:29   浏览量:0

Antimony trioxide masterbatch is widely used in engineering plastics such as polyamide (PA), polycarbonate/ABS blends, and polybutylene terephthalate (PBT), where halogenated flame retardants require an antimony synergist. In glass-filled engineering grades, the addition level of Sb2O3 masterbatch often needs modest compensation, because glass fibres dilute the polymer phase and effectively raise the required flame-retardant concentration in the matrix. A typical starting point is the standard halogen-to-antimony ratio (about 3:1 by weight for decabromodiphenyl ether systems), adjusted upward slightly for highly filled compounds.

Dispersion is critical in engineering plastics, which are typically processed at higher temperatures and higher shear than commodity polyolefins. A well-compounded masterbatch with a carrier resin matched to the base polymer—for example PA6 or PBT carriers—ensures that the Sb2O3 particles wet out and distribute uniformly during twin-screw compounding. Poor dispersion shows up as brittle failure in impact testing and as inconsistent flame-retardant performance between samples from the same batch.

Moisture deserves special attention. Polyamides are hygroscopic, and moisture at processing temperature can hydrolyse the polymer and agglomerate filler particles. Masterbatch and regrind should be dried to the resin supplier's specification before moulding, and hopper dehumidification is recommended for PA compounds. Batch-to-batch consistency should be verified through the supplier's Certificate of Analysis, checking Sb2O3 content, particle size distribution, and volatiles. For processors sourcing flame-retardant compounds for electrical enclosures, connectors, or appliance housings, consistent masterbatch quality directly supports UL94 V-0 performance and repeatability in every production run.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们