服务热线:
18971017202
您的位置:首页 >> 新闻中心

Choosing Sb2O3 masterbatch or tetrabromobisphenol-A route for ABS/PBT engineering plastics

发布日期:2026-11-21 05:34:31   浏览量:0

For compounders running ABS, PBT or PC/ABS with brominated FRs, the delivery form of antimony trioxide matters more than in commodity PP.

Why masterbatch wins in engineering plastics. ABS and PBT processing windows (220 to 260 C) allow full dispersion of masterbatch carriers, but direct powder adds dust into hygroscopic resins and promotes moisture pickup that hydrolyzes PBT chain ends. A masterbatch with ABS, PBT or PC carrier is preferred; PE or PP carriers reduce impact strength and heat-deflection temperature in PBT.

Glass-fibre compensation. In GF-reinforced PBT or PA systems, glass occupies 20 to 40 percent of volume and both powder dispersion and throughput suffer. Increase masterbatch dosage by roughly 10 to 15 percent over the calculated Sb2O3 equivalent, or pre-dry and gravimetrically pre-blend.

Bromine-to-antimony ratio. For decabromodiphenyl ethane in ABS the classic window is about 3:1 Br/Sb atomic ratio; below 2:1 char quality drops in UL94 V-0 at 1.6 mm, above 4:1 there is only cost penalty plus haze gain in gloss parts.

Moisture control. Masterbatch carriers based on PBT must be dried below 0.05 percent moisture before dosing; Sb2O3 itself is inert but the carrier hydrolyzes. Vacuum drying 4 hours at 120 C is standard practice.

Supplier checks. Ask for: carrier resin data sheet, Sb2O3 content by XRF certificate per batch, particle size D98 below 3 microns for thin-wall parts, and a re-dispersion test after 6 months storage at 40 C.

Buyers comparing Sb2O3 masterbatch versus powder routes for ABS, PBT and PC/ABS compounds can use these parameters as an acceptance baseline.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们