Antimony trioxide masterbatch is a practical option for unsaturated polyester (UP) gel coats and castings that need flame retardancy without handling fine powder on the shop floor. This guide covers where masterbatch fits, how to keep the cure window safe, and what to verify before signing with a supplier.
Why masterbatch in UP systems
UP resins are usually mixed with styrene, peroxide initiator and promoter shortly before use. Adding dry Sb2O3 powder at this stage risks poor wetting, settled agglomerates and dusty handling. A masterbatch — Sb2O3 pre-dispersed in a compatible polyester or styrene-soluble carrier — disperses faster under normal mixing and keeps dosing cleaner.
Typical loading: when combined with a brominated or chlorinated FR, maintain the halogen-to-antimony ratio near 3:1 by weight. In gel coat, keep total solids sensible so viscosity stays sprayable; verify with your resin supplier's technical data.
Cure-safety cautions
- Initiator/promoter chemistry: some Sb2O3 grades and carriers can interact with cobalt promoters. Trial a small batch first: check gel time and peak exotherm against your control sample. A shift of more than ~10% in gel time means you should re-balance promoter level.
- Styrene compatibility: the carrier must dissolve/disperse cleanly in styrenated resin. Poor compatibility shows up as fisheyes, Orange-peel gel coat surface or soft cured film.
- Settling: in low-viscosity spray gel coats, keep recirculation gentle but continuous; check a bottom sample from the drum before long holds.
Quality targets to confirm with the supplier
- Sb2O3 assay (99.5%+ for high-spec grades) with a current CoA per lot.
- Particle size: D50 around 0.8–1.5 µm, D97 controlled, no coarse tail (settled grit causes pinholes in gel coat).
- Whiteness consistency if color-critical.
- Volatility and moisture spec, plus packaging integrity (sealed, palletized, dry storage).
- Carrier identity in the masterbatch TDS — matches your resin chemistry.
Pre-signing supplier checklist
- Ask for the last three CoAs and cross-check lot numbers against retained samples.
- Run a one-batch trial in your actual resin system and record gel time, exotherm, dispersion microscope check, and cured hardness.
- Agree a dispute clause that names the testing standard version and requires sealed duplicate samples within a fixed window (e.g. 30 days from arrival).
- Confirm labeling, batch traceability and packaging spec in the contract appendix.
Getting these points in writing before the first PO is cheaper than fighting a quality claim after a production run is scrapped.