服务热线
18971017202
Antimony trioxide (Sb2O3) is rarely used alone in polyolefin (PE/PP) insulation and sheathing compounds; it acts as the synergist half of a halogen–antimony flame-retardant system, typically with decabromodiphenyl ethane (DBDPE) or chlorinated paraffins. Three practical points govern formulation.
First, the synergy ratio. A Br:Sb mass ratio near 3:1 is the accepted starting window for polyolefins; deviations of more than ±15% usually show up as either cost waste (excess Sb2O3 adds opacity and brittleness without LOI gain) or insufficient gas-phase radical quenching. Compounds requiring low smoke should shift part of the antimony load toward tin or zinc borates (5–15% of total FR package) rather than raising Sb2O3 dose.
Second, processing stability. Polyolefin compounding at 180–220°C is well within Sb2O3 thermal tolerance (sublimation onset >500°C), but the halogen partner is not: DBDPE begins to degrade above ~325°C, so screw configuration and residence time must be checked when switching Sb2O3 grades. Fine grades (D50 0.8–1.5 µm) disperse faster but agglomerate more readily; a pre-dispersed masterbatch (40–60% Sb2O3 in LLDPE or EVA carrier with MFI matched to the compound) gives cleaner color uniformity than powder blending, especially for black or grey sheathing where white specks are visible defects.
Third, supplier qualification. For each lot, verify CoA values: purity ≥99.5%, moisture <0.3%, D50 and D97 within the agreed grade window, and lead/iron impurities within limits for cable applications (electrical conductivity and long-term aging sensitivity). Retain samples and re-verify per lot on incoming inspection; annual requalification of the grade is standard practice in cable standards audits.