Flame-retardant PVC conveyor belt covers (mining, port, warehouse lines) rely on a well-tuned antimony trioxide masterbatch to pass FR standards without sacrificing abrasion resistance.
Flame Retardant Package
- Maintain the classical halogen-antimony synergy at roughly a 3:1 chlorine-to-antimony molar ratio; with chlorinated paraffin (CP-52/70) as the halogen source, rebalance the Sb2O3 dose upward when CP chlorine content is on the lower end.
- Typical Sb2O3 loading on belt cover compounds lands in the 6–10 phr range; running the FR package too hot degrades flex fatigue and cover hardness consistency.
- Add 3–6 phr zinc borate where smoke density and afterglow suppression matter (enclosed mine tunnels), accepting a modest LOI trade-off vs. pure Sb2O3.
Masterbatch Practical Points
- Choose a flexible PVC-compatible carrier (plasticized PVC or EVA) with plasticizer content declared on the CoA to avoid plasticizer migration bleeding into the finished cover.
- Fine-grade Sb2O3, D50 around 0.8–1.5 µm, gives smoother cover surfaces and less plate-out on calender rolls.
- Pre-dry the masterbatch if storage humidity exceeded 60% RH; moisture causes surface haze and voids in hot-press splicing.
Incoming QC
- CoA: Sb2O3 content ≥ 99.5% (or declared grade), moisture < 0.3%, Pb/Fe impurities within spec.
- Particle size: D50/D97 confirmed per lot, not just per product family.
- Run a 2-roll mill dispersion check and a small calender trial; watch for white specks and gasket-like plate-out.
Records
Retain a 200 g sealed sample per lot for 12 months, tied to belt batch numbers, so any certification retest can be duplicated without resampling from stock.