服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for EPS/XPS Foam Beads: Dosing, Cell Structure and CoA Checks (Batch 103)

发布日期:2026-11-21 05:34:57   浏览量:0

Antimony trioxide (Sb2O3) masterbatch remains the standard halogen-synergy partner in expandable EPS and extruded XPS foam insulation grades. Key technical points for buyers and compounders:

Synergy and dosing. Maintain the classic ~3:1 bromine-to-antimony molar ratio. For EPS beading impregnation routes, the masterbatch or Sb2O3 powder is blended into the polymer before or during suspension polymerization; final loading is set by the demanded flame class. Retune the Br/Sb ratio when brominated polystyrene (BPS) is substituted for HBCD-type systems, since effective bromine fraction differs.

Cell structure watch. Excess fine Sb2O3 ash can act as a nucleating site and shrink cell size, raising foam density and thermal conductivity (λ). Verify λ and compressive strength on trial blocks, not just from data sheets, when switching supplier or grade.

Processing checks. For XPS extrusion, monitor melt pressure and screw wear — agglomerates cause surface streaks and pinholes in the board skin. Pre-dry carrier resin if storage humidity exceeds ~60% RH; moisture above 0.3% in the masterbatch destabilizes foaming.

CoA qualification per lot. Confirm purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm (D97 declared), lead and iron impurity limits, and antimony content within ±1% of nominal. Keep a retained sample of each lot and requalify annually.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们