服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch Selection for Glass-Filled PA66 Connectors & Cable Ties

发布日期:2026-11-21 05:34:57   浏览量:0

For PA66 with 30% glass fibre (electrical connectors, cable ties, coil bobbins), antimony trioxide masterbatch selection is governed by three parameters:

1. Carrier and let-down

PA66 absorbs 2-3% moisture before processing; a PE/PP carrier introduces a small but real compatibility risk. Prefer PA6/PA66-carrier masterbatches (40-50% carrier), dosed to deliver 4-6% Sb2O3 in the final compound, paired with a brominated FR (typically 10-13%) holding Br:Sb near 3:1 on a molar basis. Glass fibre dilutes both FR and synergist: recompute ratios on the polymer fraction, not total mass.

2. Dispersion and melt handling

Fillers raise melt viscosity; the masterbatch must disperse under the same high-shear screw profile used for the glass (shear-mixing elements downstream of the fibre feeder to limit fibre breakage). Pre-dry the masterbatch to moisture <0.2% (80-100°C, 4 h) to avoid PA66 hydrolysis and molecular-weight loss; verify moisture <0.3% on CoA.

3. QC and lot qualification

Required CoA items: Sb2O3 purity ≥99.5%; fine grade D50 0.8-1.5 µm for thin-wall connector sections; Pb <50 ppm / Fe <100 ppm for electrical use; whiteness for natural-color parts; moisture <0.3%. Acceptance per lot: colour/ash uniformity ±10%, plus a moulding trial on the actual tool checking UL94 V-0 at 1.6 mm and 0.8 mm, glow-wire behaviour for connector housings, and dielectric strength where the part is an insulator. Retain ~200 g samples per lot for 12 months and requalify annually on long-running connector programs.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们