服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Polypropylene Nonwoven Fabrics: Melt-Blown Filtration and Fine-Fiber Dispersion

发布日期:2026-11-21 05:35:01   浏览量:0

Flame-retardant polypropylene nonwovens (melt-blown and spunbond filtration media, hygiene barriers) require antimony trioxide supplied as a PP-carrier masterbatch to avoid powder fly-out in fine-fiber web formation.

Carrier and dosing: Use a high-MFI PP carrier (MFI 20-60 g/10 min) matched to the melt-blown resin; typical addition 3-5 wt% Sb2O3 with a molar Br:Sb ratio of ~3:1 against DBDPE or brominated SPS. Over-dosing stiffens fine fibers and raises web brittleness-verify the hand-feel window on trial batches.

Dispersion and process control: Filter melt through ≥80-mesh screens only where die geometry permits, and monitor screen pressure rise as an indirect dispersion indicator. Watch for die-tip plate-out and surging on long runs; a two-roll bench dispersion check before melt-blowing catches coarse agglomerates that produce pinholes and weak spots in 20-50 g/m² webs.

QC and supplier checks: CoA per lot: purity ≥99.5%, moisture <0.3%, D50 0.8-1.5 µm (fine grade mandatory for melt-blown), lead <50 ppm, iron <100 ppm. For hygiene-grade media verify no heavy-metal migration beyond the applicable safety specification, and test LOI plus vertical burn on the composite laminate-not the web alone-if the end use is laminated. Keep a 200 g retained sample per lot for 12 months.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们