服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 masterbatch for HDPE blow-molded containers & industrial drums (UN-rated packaging)

发布日期:2026-11-21 05:35:07   浏览量:0

HDPE blow molding for chemical drums and UN-certified packaging runs at 190-220°C with high shear in the accumulator head; Sb2O3 masterbatch must disperse fully to avoid gels and weak weld lines that compromise drop-test certification.

Carrier and dosing - Select HDPE carrier masterbatch (MFI 4-8 g/10min at 190°C/2.16kg) matched to the drum grade; typical dose 4-6 wt% Sb2O3 with decabromodiphenyl ethyl (DBDPE) at Br:Sb ≈ 3:1 on polymer fraction. - For UN 6HA1/HG1 drums requiring incremental drop tests at -18°C, keep masterbatch ash uniformity within ±10% to prevent brittle zones at parting lines.

QC and supplier checks - Verify CoA: Sb2O3 purity ≥99.5%, moisture <0.3%, D50 0.8-1.5µm, Pb <50ppm, Fe <100ppm. - Confirm drop-test (0.8-1.2m, per lot), ESCR (bent-strip) retention on trial drums, and no surface bloom after 40°C storage. - Run 2h pre-dry at 80°C if masterbatch storage RH exceeds 60%.

Commercial terms - Require per-lot retained samples (200g, 12 months) and annual requalification to keep UN certification data current.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们