服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Extrusion Coating & Lamination Films: Feed Uniformity, Adhesion & Line-Trial Qualification

发布日期:2026-11-21 05:35:08   浏览量:0

Application focus: Extrusion coating of kraft paper, aluminum foil laminates, and BOPP sealant layers where flame retardancy must coexist with strong adhesion and optical clarity of the laminate.

Key technical points:

  • Carrier selection: Use a low-MFI LDPE or EVA copolymer carrier matched to the coating resin; mismatched MFI causes surging and unstable coat weight. Declare the antioxidant package to avoid odor migration in food-adjacent packaging.
  • Halogen synergy: Pair with brominated polystyrene or DBDPE at a Br:Sb molar ratio of ~3:1; verify the ratio on the polymer fraction after accounting for carrier weight.
  • Dose economics: Typically 3–5 wt% Sb2O3 in the coating layer; higher loadings reduce heat-seal strength of the inner layer — confirm peel strength on laminated trials.
  • Dispersibility: Fine grades with D50 0.8–1.5 µm prevent die lip buildup and streaks at thin coat weights (15–30 g/m²). Ash uniformity across the web should be within ±10%.
  • CoA requirements: Antimony content ≥80% equivalent Sb2O3, purity ≥99.5% on the powder basis, moisture <0.3%, Pb <50 ppm, Fe <100 ppm, and whiteness consistent between lots.
  • Line-trial qualification: Coat-weight uniformity (±5% across the web), adhesion (T-peel, laminate-specific), opacity/haze, and burn performance on the finished laminate, not the coating alone.
  • Retention: 200 g per-lot retained sample, archived 12 months, linked to batch number and roll ID.

Why it matters on the line: In extrusion coating, every instability compounds — feed surging shows up as gauge bands, and gauge bands show up as customer claims on the finished laminate. A masterbatch engineered for the carrier and validated at the die saves more than it costs.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们