服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Wire & Cable Jacketing: Surface Quality, Spark Testing and Long-Run Extrusion Stability

发布日期:2026-11-21 05:35:10   浏览量:0

Antimony trioxide (Sb2O3) masterbatch is the halogen-antimony synergist of record for flame-retardant cable jacketing and insulation compounds. In continuous extrusion over wire and cable lines, three problems dominate: surface defects, spark-test failures, and dispersion drift over long runs.

Carrier and formulation. Load the masterbatch onto the same polymer family as the jacket compound (flexible PVC, HFFR-PE, TPE) so the carrier melt index and plasticizer compatibility match the host. For flexible PVC jacketing, dose the masterbatch to hold a total Sb2O3 loading consistent with the flame-retardant package (typically 4–7 wt% Sb2O3 on compound with a ~3:1 halogen:Sb molar ratio using organohalogen or chlorinated paraffin sources); for HFFR-PE sheathing, pair with ATH/MDH or brominated flame retardants at the specified 3:1 halogen:Sb window verified on the specific resin.

Surface quality on calendered/extruded jacket. Plate-out and matte streaks on glossy jacket surfaces come from oversized agglomerates (D97 control) and fines. Specify D50 in the 0.8–1.5 µm band with a declared D97, and request white-uniformity data across lots. A two-roll mastication dispersion check on the incoming masterbatch, followed by a line trial with surface-gloss mapping, catches drift before a full production run.

Spark test and electrical integrity. In-line spark testers flag pinholes and inclusions; agglomerates and volatiles are common culprits. Require CoA per lot with moisture <0.3%, purity ≥99.5%, Pb <50 ppm (RoHS-aligned where specified), and low volatile content. Pre-dry hygroscopic carrier systems and monitor melt filtration pressure: a rising pressure curve across the run signals agglomerate breakthrough and predicts spark-test failures downstream.

Long-run stability. Over an 8-hour campaign, track jacket OD, spark count per km, and gloss. Rising spark rate or falling gloss mid-run indicates additive migration or screw wear interaction with the Sb2O3 package; schedule intermediate screw pulls and verify anti-plate-out behavior at the 40°C surface condition for coils stored before shipping.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们