服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for PVC Foam Core Layers: Cell Structure Control and Kicker Ratio Tuning

发布日期:2026-11-21 05:35:09   浏览量:0

Free-foamed rigid PVC board andProfile extrusions rely on a balanced nucleation/growth window. Antimony trioxide masterbatch participates in that window because halogen-Sb flame retardancy interacts with the blowing package (ADC + ZnO kicker).

Formulation guidance (polymer fraction): - Dose: 3-5 wt% Sb2O3 delivered; adjust the ADC kicker DOWN (~10-15%) when switching from powder to masterbatch, since carrier resins (rigid PVC K-value 57-62 or EVA) already carry lubricant. - Ratio: keep halogen:Sb near 3:1 molar; CP-52/70 pairs cleanly. - Particle size: fine grade D50 0.8-1.5 µm prevents cell-wall puncture and surface specks on the skin layer.

Processing checks: - Barrel zones: keep melt ≤190 °C; ADC decomposition gases plus Sb volatiles accelerate plate-out above 200 °C — clean die and calender rolls every 4 h. - Density target 0.55-0.65 g/cm³: verify cell uniformity on a polished cross-section; coarse cells (>0.5 mm) signal poor dispersion — raise screw shear or reduce dose 0.5%.

CoA acceptance per lot: purity ≥99.5%, moisture <0.3%, Pb <50 ppm, whiteness ≥96. Retain a 200 g sample for 12 months tied to the board batch number for warranty traceability.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们