服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Automotive Interior Trim and Instrument Panels

发布日期:2026-11-21 05:35:11   浏览量:0

Automotive interior components — instrument panels, door trim, center consoles, and pillar covers — must meet OEM flammability specifications (most commonly FMVSS 302) while maintaining dimensional stability and low volatile organic compound (VOC) emissions across a wide service temperature range.

Formulating with Sb2O3 masterbatch in TPO, PVC, and polyurethane skin materials

  • For TPO interior skins and substrates, a polypropylene-based masterbatch carrier matches the host resin MFI and disperses cleanly without surface bloom on soft-touch coatings.
  • Use fine particle grades (D50 0.8–1.5 µm) to minimize glare-textured surface haze on grain surfaces and to prevent white speck defects visible under cabin lighting.
  • Pair Sb2O3 with brominated or chlorinated co-additives at approximately a 3:1 halogen-to-antimony molar ratio; for interior PVC with chlorinated polymer base, the existing chlorine content can reduce the required halogen co-additive dose.

Thermal aging and fogging checks

  • Interior parts see sustained 85–105°C surface temperatures in sun-exposed zones. Run 500–1,000 hour heat-aging trials to confirm the antiplate-out and color-stability performance of the masterbatch carrier (avoid carriers that volatilize and contribute to windshield fogging).
  • Verify the plasticizer system in flexible PVC interior skins stays compatible with the masterbatch carrier declaration; plasticizer migration can carry antimony compound to the surface over time.

Supplier and CoA checklist for Tier 1s and molders

  • CoA purity ≥99.5%, moisture <0.3%, heavy metals: Pb <50 ppm, Fe <100 ppm.
  • D50 and D97 particle size distribution consistent lot to lot.
  • Color/whiteness consistency for light-gray and beige interior color matches.
  • Ask for per-lot retained samples and a two-roll mill dispersion check before molding trials.
  • Trial the grade on the actual injection-molding or calendering line, checking FMVSS 302 burn rate on finished parts, not just compound coupons.

Consistent lot-to-lot quality and documented dispersion testing separate a qualified automotive interior supplier from a bulk powder vendor.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们