服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Automotive Interior Trim and Instrument Panels

发布日期:2026-11-21 05:35:12   浏览量:0

Automotive interior components — instrument panels, door trim, center consoles, and pillar covers — must meet OEM flammability specifications (most commonly FMVSS 302) while retaining dimensional stability and low VOC emissions across a wide service temperature range.

Formulation in TPO, PVC and polyurethane interior substrates

  • In TPO interior skins and substrates, a polypropylene-based Sb2O3 masterbatch matches the host resin MFI and disperses cleanly without blooming onto soft-touch coatings.
  • Select fine particle grades (D50 0.8–1.5 µm) to minimize haze on grained surfaces and to avoid white speck defects under cabin lighting.
  • Combine with brominated or chlorinated co-additives at roughly a 3:1 halogen-to-antimony molar ratio; for interior PVC grades the chlorine inherent in the polymer lowers the additional halogen co-additive requirement.

Heat aging, fogging and color stability

  • Sun-exposed zones reach sustained 85–105°C surface temperatures; run 500–1,000 h heat-aging to confirm the masterbatch carrier does not volatilize or contribute to windshield fogging.
  • Check color fastness of light-gray and beige formulations by comparing ΔE before and after aging against a retained standard plaque.

Supplier and CoA verification for Tier 1 molders

  • CoA: purity ≥99.5%, moisture <0.3%, Pb <50 ppm, Fe <100 ppm.
  • D50/D97 size distribution consistent within ±10% between lots.
  • For light interior shades request whiteness ≥96 and per-lot retained samples (200 g, 12 months).
  • Confirm a two-roll bench dispersion check precedes each molding trial, plus a QUV weathering comparison against a retained plaque.

A qualified automotive interior grade is defined by reproducible dispersion, controlled VOC/fogging behavior, and a fully traceable batch record rather than by flame-retardant loading alone.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们