服务热线:
18971017202
您的位置:首页 >> 新闻中心

**Sb2O3 masterbatch for LED diffuser & light-guide polymers: transparency-friendly dosing**

发布日期:2026-11-21 05:35:14   浏览量:0

Sb2O3 is not refractive-friendly in PMMA or PC at light-guide thicknesses, so diffuser compounders keep effective Sb2O3 low (roughly 2-4% on polymer) and lean on halogen co-additives at about 3:1 Br/Sb to hold UL94 E at the thinnest wall. Masterbatch over powder keeps specks out of a backlit surface.

Use a matched carrier: PMMA masterbatch for PMMA diffuser sheet, PC or PC/ABS carrier for LED housing parts. Pre-dry PMMA and PC thoroughly (moisture below about 0.1%) before moulding; moisture shows up as haze and silver streaks.

Watch the plate-out: fine D50 0.8-1.5um grades bloom slowly on a polished cavity, so schedule mould cleaning. On CoA, check purity 99.5% and above, moisture under 0.3%, Pb under 50ppm, particle D50/D97, and whiteness (it feeds into transmittance). Run a haze and transmittance check on a trial plaque before committing the batch.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们