1. Application Context
Silicone rubber (VMQ/FVMQ) and fluorosilicone seals are used in high-temperature automotive, aerospace and food-service applications where halocarbon flame retardancy is required. Adding Sb2O3 flame retardant must not compromise the peroxide or platinum cure system or the elastic recovery of the seal.
2. Formulation Guidance
- Carrier selection: use a low-volatility, high-temperature-stable carrier compatible with the silicone matrix (premium-grade precipitated silica or silicone-compatible carrier masterbatch). Avoid carriers with residual moisture that hydrolyse the silicone network.
- Dose window: 3–5 wt% effective Sb2O3 on the compound, paired with a brominated FR at ~3:1 Br:Sb molar ratio (e.g. decabromodiphenyl oxide or brominated epoxy oligomer).
- Fine grade: D50 0.8–1.5 µm to prevent surface bloom and to keep the compression-set and hardness within specification.
3. Processing & Cure Compatibility Checks
- Cure interference: verify peroxide/platinum cure is not retarded by Sb2O3 surface impurities; run a cure-time (t90) comparison with and without masterbatch — drift must stay within 10–15%.
- Pre-dry: dry the masterbatch 2–4 h at 70–80 °C when storage relative humidity exceeds 60% to avoid moisture-induced voids in cured parts.
- Compression-set: 22 h at 150–175 °C; record set % vs. baseline (red line ≤ 10% relative increase).
- Bloom watch: after oven ageing at 200 °C/70 h, inspect for surface exudation (Sb2O3 bloom) on the seal cross-section.
4. CoA Verification per Lot
- Purity ≥ 99.5% Sb2O3
- Moisture < 0.3%
- Particle size D50 0.8–1.5 µm / D97 specified
- Pb < 50 ppm, Fe < 100 ppm
- Whiteness consistency across lots (ΔE < 1)
5. Qualification & Record-Keeping
- Run LOI / vertical-burn on cured plaques (not raw compound) for the target reaction-to-fire class.
- Keep a 200 g retained sample per lot for 12 months.
- Record cure-profile, compression-set and bloom data in the per-lot quality file; re-qualify the grade annually or on any carrier/FE change.