服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for PVC Heat-Shrink Tubing & Battery Terminal Insulation

发布日期:2026-11-21 05:35:29   浏览量:0

1. Application & Masterbatch Advantages

Heat-shrink tubing and battery terminal insulators are thin-wall (0.3–1.0 mm) flexible PVC products demanding flame retardancy without sacrificing shrink ratio, dielectric strength, or surface finish. Using a masterbatch over dry powder addition delivers:

  • Cleaner dosing — no dust loss during compounding; antimony content is certified per batch.
  • Finer dispersion — pre-wetted carrier avoids undispersed Sb2O3 agglomerates that cause white specks or pinholes in thin walls.
  • Lot-to-lot consistency — key for UL 94 / IEC 60684 shrink-tube approvals where CoA traceability is audited.

2. Carrier & Formulation

  • Carrier: flexible PVC (K-value 58–65) or EVA–CPE blend with a declared plasticizer content (DINP/DOA), matching the base compound's polarity for clean let-down.
  • Dose: effective Sb2O3 3–5 phr in the final compound.
  • Halogen synergy: with chlorinated paraffin CP-52/70 (chlorine source) target Cl:Sb ≈ 3:1; with a brominated source (e.g. DBDPE) retune Br:Sb ≈ 3:1 on effective bromine, not compound weight.
  • Fine grade: D50 0.8–1.5 µm to minimize haze, surface bloom, and thin-wall puncture in shrink tubing.

3. Processing Checks

  • Pre-dry: 2–4 h at 70–80 °C when storage exceeds 60% RH to prevent moisture-induced splay and dielectric loss.
  • Melt temperature: keep ≤190 °C; monitor die and sizing tooling for plate-out (whitening/soot) over 2–4 h runs.
  • Shrink test: verify shrink ratio and recovery force on the finished tube — Sb2O3 at correct dispersion must not impair shrink performance.
  • Dielectric: per-lot dielectric strength and surface resistivity on thin-wall samples (typical requirement ≥15 kV/mm for 0.5 mm insulation grade).

4. Qualification & CoA

  • CoA checks per lot: purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm, Pb <50 ppm, Fe <100 ppm.
  • End-product tests: UL 94 V-0 at target wall thickness, cold-bend at −20 °C, heat-aging (100 °C) retention of tensile and dielectric properties.
  • Retained sample: 200 g per lot, held 12 months for re-test and dispute resolution.

5. Supplier Verification

Audit the masterbatch supplier for: carrier composition disclosure (plasticizer type/level), fine-grade D50/D97 control, CoA batch traceability, and white-consistency across lots. Require a line-trial qualification before batch commitment.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们