Application Context
Rigid PVC pipe fittings (elbows, tees, couplings) and solvent-cemented joints are a
high-shear, high-clarity application where flame-retardant masterbatch must not
compromise joint strength or surface finish.
Masterbatch-over-Powder Advantages
- Clean, dust-free dosing on automatic batching lines (powder carry-over contaminates
downstream hoppers and causes inconsistent flame-retardant levels).
- Consistent lot-to-lot Sb2O3 content for reproducible UL94 / reaction-to-fire results.
- Fine D50 0.8-1.5 µm grade avoids white specks on molded fitting surfaces and at the
cement-bonded joint line.
Dosing & Synergy Window
- Rigid-PVC carrier matched to K-value 58-65 (or EVA/CPE polarity-matched carrier).
- Effective Sb2O3 dose 3-5 phr with Cl:Sb ≈ 3:1 against chlorinated paraffin CP-52/70;
retune to Br:Sb ≈ 3:1 on effective bromine when a brominated FR is co-used.
- Optional zinc borate 30-50% replacement for smoke suppression (careful: reduces
flame-retardant efficiency, verify with full-scale burn).
Processing Controls
- Melt temperature ≤ 190 °C to limit plate-out on die and sizing tools.
- Pre-dry 2-4 h at 80 °C when storage exceeded 60% RH (moisture causes streaking and
surface defects on molded fittings).
- Two-roll mill dispersion check + screen-pack pressure watch on extrusion trials.
End-Product QC
- Solvent-cement joint bond strength drop < 10% vs. unfilled control.
- Cold-bend test at −20 °C; impact (falling dart) with < 10% retention loss.
- UL94 V-0 / EN 13501-1 reaction-to-fire at target wall thickness.
- CoA per lot: purity ≥ 99.5%, moisture < 0.3%, Pb < 50 ppm, Fe < 100 ppm,
whiteness consistency.
- Retain 200 g per lot for 12 months.
Supplier Qualification Checks
- Confirm fine-grade D50/D97 on CoA, not just purity.
- Request two-roll dispersion + joint-strength trial data before batch commitment.