服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for EVA Foam Slippers & Footbeds — Formulator & Purchasing Guide

发布日期:2026-11-21 05:35:33   浏览量:0

Why Masterbatch Over Powder

EVA/PE injection or compression foam moulding benefits from masterbatch dosing over raw powder: - Clean & dust-free dosing — fine Sb2O3 powder causes airborne dust and feeding variation; masterbatch locks it in an EVA carrier. - Consistent per-batch antimony loading — shot-to-shot flame-retardant uniformity on finished foam parts. - Better dispersion — pre-compounded pellets distribute Sb2O3 evenly before blowing, avoiding Sb-rich specks.

Carrier & Dose

  • Carrier: low-MFI EVA (typically MFI 1–6) matched to the base compound; verify carrier MFI within 10–15% of base resin to avoid moulding defects.
  • Effective Sb2O3 dose: 3–5 wt% on the polymer fraction for V-0/UL94 vertical-burn targets in foamed EVA.
  • Halogen synergy: pair with chlorinated paraffin (CP-52/70) or brominated FR (DBDPE) at a ~3:1 Cl:Sb or Br:Sb molar ratio on effective halogen — retune against the base compound's inherent halogen content.

Blowing-Agent Interaction

  • EVA foam relies on chemical blowing agents (ADC — azodicarbonamide). Sb2O3 can affect decomposition kinetics:
  • Kicker effect: switching from powder to masterbatch may shift ADC activation; reduce the kicker dose ~10–15% as a first trial to keep cell structure.
  • Watch cell uniformity (±10% density check) and surface skin quality — over-dosing Sb2O3 can coarsen cells and raise surface bloom.

Process & QC Checks

  • Pre-dry: 2–4 h at 70–80 °C if storage exceeded 60% RH (moisture destabilises foam structure).
  • Mould release / surface bloom: fine-grade D50 0.8–1.5 µm reduces migration/whitening on the foam surface.
  • Compression-set on finished slipper/footbed — antimony load must not degrade recovery.
  • Flame test on finished plaques, not pellets: run LOI or vertical-burn on moulded foam samples (foam density strongly affects rating).
  • CoA verification per lot: purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm, Pb <50 ppm, Fe <100 ppm.

Supplier Qualification

  • Provide per-lot CoA with antimony content and particle size; retain a 200 g sample 12 months per lot.
  • Require line-trial qualification before full batch commit (foam trial: density, cell uniformity, mould release, flame rating).
  • Annual requalification recommended given raw-material drift.

Technical guidance for EVA foam converters. Validate against your specific compound and moulding parameters before production.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们