服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Vinyl Ester & Bisphenol-A Epoxy FRP Pipes

发布日期:2026-11-21 05:35:34   浏览量:0

Flame-retardant, corrosion-resistant FRP pipe made from vinyl ester or bisphenol-A epoxy resin is a demanding application for antimony trioxide. This guide covers the engineering, dosing and supplier-qualification points a resin compounder should check before committing a batch.

1. Why masterbatch over raw powder

  • Clean dosing in catalyzed systems: vinyl ester / epoxy pipes are often pultruded, filament-wound or centrifugally cast with peroxide catalysts and gel-time accelerators. Powder Sb2O3 added loose risks dusting, poor wet-out and local gel-time drift. A resin-compatible masterbatch gives uniform dispersion and predictable gel characteristics.
  • Viscosity control: powder raises resin paste viscosity and promotes settling; a low-filler masterbatch keeps the matrix viscosity within the winding / pultrusion window.

2. Carrier & compatibility

  • Use a low-viscosity, styrene-compatible carrier (or a reactive diluent-dispersed masterbatch) matched to the vinyl ester / epoxy resin system. Verify that the carrier does not accelerate gelation or exotherm.
  • For bisphenol-A epoxy pipes cured with anhydrides / amines, confirm the carrier does not carry moisture or acidic residues that interfere with cure.

3. Dosing & halogen-antimony synergy

  • Typical effective Sb2O3 dose: 3–5 wt% on resin. Pair with a brominated resin (e.g. brominated epoxy vinyl ester) or a halogenated additive at roughly 3:1 halogen:Sb (Br:Sb ≈ 3:1) by weight on the halogen compound.
  • If zinc borate is added for smoke suppression, retune the Sb2O3 dose down 10–15% to hold the target flame class.

4. Process & QC checks before batch commit

  • Gel-time / exotherm window: run a small trial and accept only if cream-gel-tack-free time shifts < 10–15% vs the non-flame-retarded reference — drift beyond this red line means cure interference.
  • Settling on filament winding / centrifugal casting: check the filled resin stays dispersed through the pot life; re-agitate if settling occurs.
  • Melt or cure plate-out: for pultruded profiles, watch die / mandrel build-up during the trial run.
  • Final-part flame test: verify LOI / vertical burn / ASTM E84 or EN 13501-1 on the finished pipe wall thickness, not on lab plaques.

5. CoA verification from supplier

Demand per-lot CoA confirming: - Purity ≥ 99.5% Sb2O3 - Moisture < 0.3% - Particle size D50 0.8–1.5 µm, D97 stated - Pb < 50 ppm, Fe < 100 ppm - Whiteness consistency (ΔE < 1 between lots) - Retained sample: 200 g per lot, held 12 months, batch number cross-linked to the CoA and the inspection report for traceability.

6. Line-trial qualification

Never commit a full order on paper data alone. Require a line trial on the actual pultrusion / winding / casting equipment, verify flame class, corrosion barrier integrity and gel-window stability, then lock the supplier grade for annual re-qualification.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们