Application Context
GF-PP (10–40% glass fibre) is widely used for automotive undershields, engine-bay covers and battery trays that must meet FMVSS 302 / UL94 flammability without compromising dimensional stability or long-term heat ageing.
Why Masterbatch over Powder
- Cleaner dosing on automated compounding lines; powder adds dust and segregation risk with glass fibre.
- More uniform halogen–antimony dispersion through the matrix → more consistent flame rating.
- Consistent lot-to-lot whiteness and CoA traceability for OEM release.
Formulation Points
- Carrier: matched PP carrier (MFI 10–25) to the base resin's MFI to avoid short-shot or segregation.
- Effective Sb2O3 dose: 3–5 wt% on the polymer fraction (i.e. excluding glass-fibre weight) — re-normalise when GF% changes.
- Halogen synergy: ~3:1 Br:Sb with a brominated FR (DBDPE / brominated epoxy oligomer), or Cl:Sb≈3:1 with chlorinated paraffin; calculate the ratio on effective halogen, not compound weight.
- Glass-fibre compensation: raise Sb2O3 by 10–15% when GF% ≥30%, because glass dilutes the polymer matrix.
Processing & QC Checks
- Pre-dry: 2–4 h at 80–100 °C if storage >60% RH, to prevent hydrolytic degradation and plate-out.
- Melt temperature: keep PP melt ≤230–240 °C; watch for die/mould plate-out over extended runs.
- Dispersion: two-roll or twin-screw bench check; filter-screen pressure rise as a dispersion proxy.
- Heat ageing: 85–105 °C, 1000 h; colour ΔE and flexural retention <10% drop are typical red lines.
- Fogging & VOC: confirm the masterbatch does not raise cabin fogging when used in interior-adjacent parts.
- Flame test: UL94 V-0 / FMVSS 302 on the final wall thickness of moulded parts, not on the compound pellet.
CoA Verification
Purity ≥99.5% | Moisture <0.3% | D50 0.8–1.5 µm | Pb <50 ppm | Fe <100 ppm | Whiteness ΔE <1 per lot. Keep a 200 g per-lot retained sample for 12 months and annual re-qualification.