服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for 3D Printing Filament (PC/ABS & PETG)

发布日期:2026-11-21 05:35:35   浏览量:0

Why Masterbatch Over Powder for FDM/FFF Filament

  • Filament requires consistent melt flow and zero coarse particles — powder dosing causes flow variance, nozzle clogs, and surface pitting.
  • Masterbatch delivers homogeneous Sb2O3 dispersion (fine D50 0.8–1.5 µm) and lot-consistent additive load → stable filament diameter (±0.02 mm) and print quality.
  • Cleaner handling: no dust in the extrusion/compounding area, safer for operator and filament quality.

Carrier Selection

  • PC/ABS filament: match carrier to the blend — ABS/SAN carrier with MFI within 10–15% of the resin; PC content raises melt temperature window, keep melt ≤260°C.
  • PETG filament: PETG-compatible carrier, pre-dry to <0.05% moisture (PETG hydrolyzes on moisture).
  • Recommend a masterbatch with the same base polymer family to avoid phase-separation and print-strength loss.

Dosing & Halogen–Antimony Synergy

  • Effective Sb2O3 3–5 wt% on polymer fraction for UL94 V-0 on the printed part.
  • Use ~3:1 Br:Sb (or Cl:Sb ≈3:1 with chlorinated compounds) — calculate on effective halogen in the flame-retardant package, not compound weight.
  • Note: flame retardancy of a printed part must be tested on the FINISHED print (layer interfaces and infill affect burn), not on the raw pellet.

Processing Checks

  • Moisture control: pre-dry masterbatch 2–4 h at 70–80 °C if stored >60% RH.
  • Melt-temperature discipline: PC/ABS ≤260 °C, PETG ≤250 °C — Sb2O3 does not decompose, but the carrier and resin do; plate-out/degassing watch on nozzle.
  • Filter/screen pressure rise on the line = dispersion proxy; verify no coarse agglomerates.
  • Diameter gauge + haze on printed coupon per lot.

CoA Verification (per lot)

  • Purity ≥99.5%, moisture <0.3%, Pb <50 ppm, Fe <100 ppm, D50 0.8–1.5 µm, whiteness ΔE<1.
  • Require a per-lot retained sample (200 g, 12 months) and full batch traceability to the filament lot.

Qualification Gate Before Commit

  • Run a trial batch on the actual filament line; check filament diameter stability, print surface (no white specks/voids), layer adhesion, and finished-part UL94 V-0/VTM-0.
  • Annual requalification recommended as carrier and resin formulations change.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们