Application Context
Glass-reinforced phenolic (PF) resins are the backbone of brake linings, clutch facings, and industrial friction parts. Adding Sb2O3 as a flame/smoke synergist improves the fire and heat performance of the moulded friction composite, but it interacts with the resin cure, glass sizing, and friction additives. This article is a formulation and QC guide for masterbatch users, not a raw-material pitch.
Masterbatch-Over-Powder Advantages
- Clean, dust-free dosing into phenolic wet mixes and pre-pregs
- Predispersed Sb2O3 avoids dry-powder segregation during tumble mixing
- Lot-to-lot consistency on effective Sb2O3 content (target ±0.1 wt%)
Formulation Points
- Effective Sb2O3 dose: 3–6 wt% on the fibre-resin system; adjust when brominated phenolic or chlorinated resin is present — retune Br:Sb or Cl:Sb to ≈3:1 on effective halogen
- Use a phenolic-compatible carrier (low-volatility novolac-compatible) so the masterbatch does not disturb the cure
- Glass sizing compatibility: Sb2O3 must not strip silane sizing or raise friction coefficient beyond the data sheet window
- Watch scorch: phenolics gel fast; keep mixing temperature below the gel-time red line (reject if gel time drifts >10–15%)
QC & Acceptance Checks
- Moulded-pad fire test (not raw mix): LOI / vertical-burn / hot-plate smoke density per lot
- Friction coefficient stability and wear rate versus a reference lot
- Heat aging 150–200°C / 100h: check surface bloom (fine D50 0.8–1.5µm minimises bloom)
- CoA verification per lot: purity ≥99.5%, moisture <0.3%, D50 0.8–1.5µm, Pb <50ppm, Fe <100ppm, whiteness ΔE<1
- 200g per-lot retained sample, 12 months; annual requalification
Supplier Qualification
- Phenolic-friction-grade track record and line-trial evidence
- Lot traceability: CoA batch ↔ retained sample ↔ production batch archive ≥5 years