服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Cast Epoxy & Thermoset Electrical Insulation (Motor Slot Liners / Coil Encapsulation)

发布日期:2026-11-21 05:35:42   浏览量:0

采购/选型要点 (English)

Why Masterbatch Over Powder in Thermosets

  • Epoxy/vinylester casting & encapsulation of motors, transformers, and stator coils demands dust-free, precisely dosed antimony trioxide.
  • Powder adds dust hazard, poor dispersion in high-viscosity resin, and risk of localized overdosing that disturbs the cure window. A liquid-compatible / low-viscosity carrier masterbatch (thermosetting-friendly carrier such as epoxy-compatible or low-MFI EVA) gives uniform Sb2O3 distribution and reproducible lot consistency.

Key Selection Checks

  1. Carrier compatibility — carrier must dissolve/mix into the base epoxy resin without phase separation or haze. Confirm viscosity match (±10–15%) so gel-time and exotherm stay stable.
  2. Effective Sb2O3 dose — typically 3–6 wt% on resin phase for motor insulation to reach UL94 / IEC 60085 thermal class with brominated epoxy (DBDPE, brominated epoxy oligomers) co-FR.
  3. Halogen:antimony ratio — target ≈3:1 Br:Sb on effective bromine (not compound weight). Retune when switching Br source.
  4. Gel-time / exotherm window — masterbatch must not shift cream→gel→tack-free time by >10–15%; a larger drift = scorch/overheating risk in thick coil sections.

Processing & QC

  • Dispersion — evaluate via filtered-pressure-rise or grindometer; target no coarse agglomerates in resin.
  • Settling stability — for casting tanks, check no sedimentation over the working cycle (≥6 months shelf for pre-mixed).
  • Post-cure thermal checks — 85–105°C/1000h heat aging, ΔE and mechanical/insulation retention <10% drop; dielectric strength per lot.

CoA Verification (per lot)

  • Purity ≥99.5%, moisture <0.3%, D50 0.8–1.5µm (fine grade), Pb <50ppm, Fe <100ppm, whiteness ΔE<1.
  • Retain 200g per-lot sample for 12 months; annual requalification; lot traceability ≥5 years.

Application Target

Motor slot liners, coil encapsulation, transformer bobbins, thermoset electrical housings — reaction-to-fire on the finished cured part, not on raw resin.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们