服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Crosslinked PE (XLPE) Heat-Shrinkable Tubing & Cable Accessories

发布日期:2026-11-21 05:35:46   浏览量:0

Application Context

Heat-shrinkable XLPE tubing and cable accessories (joint kits, termination boots, insulating sleeves) demand a flame-retardant system that survives crosslinking, heat-shrink reflow, and field aging without degrading electrical performance or mechanical integrity. Sb2O3 masterbatch is preferred over raw powder for clean dosing, fine dispersion, and lot-to-lot consistency on high-speed compounding and crosslinking lines.

Carrier & Dispersion Matching

  • Use an XLPE-compatible carrier (LDPE/LLDPE, MFI 0.5–3) or a crosslinkable silane-grafted PE when the masterbatch must itself participate in crosslinking.
  • Carrier MFI should match the base compound within ±15% to avoid melt-flow mismatch, pinholes, or uneven Sb2O3 distribution in thin-wall (0.3–1.5 mm) tubing.
  • Twin-screw compounding at 160–190 °C with adequate shear disperses fine-grade Sb2O3 without thermal stress on the peroxide.

Flame-Retardant Synergy & Dosing

  • Effective Sb2O3 dose: 3–5 wt% on the polymer fraction.
  • Halogen:Sb molar ratio ≈ 3:1, retuned on effective halogen content — use brominated (DBDPE, brominated epoxy oligomers) or chlorinated (CP-52/70) sources matched to the compound.
  • Optional zinc borate (30–50% of the Sb2O3 charge) for smoke suppression and arc-track resistance in cable accessories.

Crosslinking & Processing Checks

  • Peroxide-cure interference: run MDR t90; reject if shift exceeds 10–15% versus the unmodified compound.
  • Pre-dry 2–4 h at 70–80 °C when storage humidity >60% RH to prevent moisture-driven scorch or voiding.
  • Watch melt temperature ≤200 °C and die/mandrel plate-out during heat-shrink reflow; monitor screen-pack pressure rise as a dispersion proxy.
  • Verify gel content after crosslinking and density uniformity ±10% on finished tubing.

Qualification & CoA Verification

  • CoA minimums: purity ≥99.5%, moisture <0.3%, D50 0.8–1.5 µm, Pb <50 ppm, Fe <100 ppm, whiteness ΔE <1.
  • Per-lot: dielectric strength and 7-day water-immersion insulation resistance; cold-bend −20 °C; heat-aging 135 °C/168 h with <10% retention loss.
  • End-product fire test (UL94 V-0 / IEC 60332-1) on finished tubing and accessories, not on raw pellets.
  • Retain 200 g per-lot sample for 12 months; annual re-qualification of supplier.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们