服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Polypropylene E-Bike / UPS Battery Casings: Dosing, Impact Retention & Thermal-Aging QC

发布日期:2026-11-21 05:35:51   浏览量:0

Target application: injection-moulded PP copolymer battery boxes for e-bike, UPS and telecom backup power — thin-wall (2.5–3.5 mm), needs UL94 V-0 with heat + vibration durability.

Why masterbatch over powder for battery housings - PP copolymer carrier (MFI 8–15) matches the housing grade — no need to compromise melt flow on a 3 mm thin wall. - Pre-dispersed pellets eliminate powder specks visible on textured surfaces; lot-to-lot ash uniformity ±10% keeps V-0 stable across cavities.

Formulation guidance - Effective Sb2O3 dose: 3.5–5 (%) on polymer fraction. - Halogen partner: DBDPE or brominated styrenic; keep Br:Sb ≈ 3:1 calculated on effective bromine, not compound weight. - Impact trade-off: above ~5% Sb2O3, notched impact drops quickly; verify Dart-drop / notched Izod retention ≥85% vs unmodified at 23°C and −20°C (cold weather use). - Zinc borate 3–5% optional for smoke, watch filler loading vs weld-line strength.

Processing checks - Pre-dry masterbatch 2–4 h @ 80–90°C if stored above 60% RH. - Melt ≤230°C — brominated FR + Sb2O3 plate-out accelerates above this; clean die and vent screws every shift change. - Watch clamp-surface bloom on textured cavities; polish cycle adjustment if specks appear after 500+ shots.

CoA qualification per lot - Purity ≥99.5%; moisture <0.3%; D50 0.8–1.5 µm; Pb <50 ppm; Fe <100 ppm; whiteness ΔE <1. - UL94 V-0 on finished housing at the thinnest wall section — never on raw pellets. - 200 g per-lot retained sample, 12 months; annual requalification against first-run control plaques.

Quality acceptance for the purchaser - Run a moulding trial per lot at the actual housing wall thickness; reject on V-0 fail or impact retention <85%. - Tie CoA lot numbers to the housing batch for warranty traceability.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们