Why Masterbatch Over Powder for Thin-Wall Parts
Household appliance housings (TV/audio/kitchen-appliance shells) are thin-wall HIPS/PS parts (0.8–2.5 mm). Adding Sb2O3 as loose powder causes three chronic defects: white specks (poor dispersion), dust hazards in the workshop, and inconsistent dosing lot to lot. A HIPS/PS-carrier Sb2O3 masterbatch solves all three — clean metering, fine dispersion, and batch consistency demanded by UL94 V-0 at those thin walls.
Dose and Synergy Window
- Use effective Sb2O3 at 2.5–4 wt% on the polymer fraction.
- With a brominated FR (decabromodiphenyl ethane, brominated epoxy oligomer or FR-245), target Br:Sb ≈ 3:1 on effective bromine, not on compound weight — recalculate on the actual bromine content of the FR grade.
- Optional zinc borate at 30–50% of the Sb2O3 loading to cut smoke and afterglow.
Carrier & Processing Checks
- Match the carrier MFI/polarity to the HIPS/PS grade (HIPS/PS carrier or a compatible SAN/styrenic carrier); verify by twin-screw trial.
- Pre-dry 2–4 h at 70–80 °C when stored above 60% RH before moulding.
- Keep melt below ~220–240 °C; watch for mould fouling / plate-out on long runs — set a mould-cleaning schedule.
- Verify dispersion on thin plaques: no visible specks at 0.8 mm, haze <2–3% against the unpigmented control.
End-Product Qualification
- Run UL94 V-0/V-1 at the final wall thickness (0.8–2.5 mm), not on thick test bars.
- Add cold-crack / drop test on the finished housing and, where applicable, FMVSS 302 or EN 13501-1 per the market targeted.
- Heat-age 85–105 °C, check colour drift (ΔE < 2) and gloss retention.
CoA Acceptance Checklist
Per lot require CoA stating: purity ≥99.5%, moisture <0.3%, particle size D50 0.8–1.5 µm (and D97), Pb <50 ppm, Fe <100 ppm, whiteness ΔE <1 vs the reference. Keep a 200 g per-lot retained sample for 12 months; link CoA lot number ↔ test report ↔ retained sample ↔ delivery batch for traceability ≥5 years.