服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch vs Powder in Extrusion Coating: Feeding and Dispersion Comparison

发布日期:2026-11-21 05:34:10   浏览量:0

Antimony trioxide (Sb2O3) is widely combined with brominated flame retardants in extruded coatings for films, tapes, and cable jackets. Choosing between an Sb2O3 masterbatch and dry powder affects feeding stability and dispersion quality.

Feeding behavior

Powder tends to flood-feed or bridge in the hopper, causing throughput fluctuation and dosing error. A masterbatch granule flows consistently and can be metered by gravimetric feeders with much tighter tolerance.

Dispersion: Sb2O3 aggregates are hard to break down in short coating extruders. Pre-dispersed masterbatch delivers finer, more uniform particle distribution, reducing surface roughness ("fish-eye") and die-tip buildup.

Practical guidance

  • Line with poor downstream QC: choose masterbatch to reduce batch-to-batch variation.
  • High-dose formulations: use a masterbatch concentrate of 60-80% Sb2O3, dosed 15-30% to balance cost and uniformity.
  • Always pre-dry hygroscopic carriers and keep masterbatch sealed; moisture causes die drool in coating lines.
  • Verify synergy ratio with the brominated retarder; mismatched ratios worsen char formation and raise torque.

For buyers, request particle size distribution (D50 typically 1-3 microns) and dispersion test reports per lot.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们