服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb₂O₃ Grade Selection for Transparent and Translucent Polymers: Haze, Whiteness and Compromise Strategies

发布日期:2026-11-21 05:34:14   浏览量:0

Using antimony trioxide in transparent PMMA, PC, or clear TPU is inherently a trade-off: the synergist is a white inorganic powder, so any meaningful loading raises haze. Formulators and buyers should plan for compromise rather than a perfect solution.

Why transparency degrades

Sb₂O₃ particles scatter light. Haze scales with refractive-index mismatch, particle size relative to visible wavelengths (worst around 200–400 nm), and loading level. Even 1–2 phr of fine Sb₂O₃ can push haze above acceptable limits in clear substrates.

Practical strategies

  1. Minimize loading by pairing with an efficient halogen FR rather than raising Sb₂O₃ to compensate.
  2. Choose the finest consistent grade (sub-micron where available) and demand COA-verified particle distribution — agglomerates are the main haze driver.
  3. Pre-dispersed masterbatch reduces agglomerates in clarity-sensitive runs.
  4. Rethink the requirement: for many enclosures, "translucency" or a frosted finish is acceptable; reclassifying the cosmetic spec often removes the problem entirely.

Buyer note

When requesting quotes, state the target haze percentage and loading window explicitly. Suppliers who cannot commit to a COA-backed top-cut on particle size are unlikely to hold clarity lot-to-lot.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们