服务热线:
18971017202
您的位置:首页 >> 新闻中心

Antimony Trioxide (Sb2O3) Masterbatch with Brominated Flame Retardants in Polypropylene: Dosage Windows for B2B Buyers

发布日期:2026-11-21 05:34:26   浏览量:0

Antimony trioxide (Sb2O3) is the essential synergist for brominated flame-retardant systems in polypropylene (PP). Typical bromine-to-antimony mass ratio runs 3:1 to 4:1, but the practical dosage window in PP is usually 4-8 wt% Sb2O3 paired with a matching bromine source, adjusted to the target UL94 rating.

Choosing a masterbatch (Sb2O3 pre-dispersed in a PP carrier) instead of straight powder improves dispersion strongly in PP, because particle agglomeration in non-polar polyolefins is the main cause of variable flame performance. For glass-fiber-reinforced PP grades, keep loadings toward higher dosage side (8-10 wt%) since fillers dilute the effective halogen-antimony interaction.

Key selection points when sourcing Sb2O3 masterbatch for PP:

  1. Carrier compatibility: use a PP-based carrier matching your resin MFI to avoid delamination or gels.
  2. Particle size and distribution: D50 of 1-3 microns with narrow distribution gives stable UL94 results and better impact retention.
  3. Impurity limits: request Pb below 0.05% and Fe below 0.005% to protect color and electrical insulation properties.
  4. Surface treatment: ask whether the Sb2O3 is coated; treated grades reduce moisture pickup and improve long-term dispersion.

Quality-control checklist for incoming batches:

  • Verify CoA values: Sb2O3 content (typ. 99.5% min), whiteness, and particle size against your spec.
  • Run a small-lot compounding trial and measure UL94 at 1.6 mm and 3.2 mm thickness.
  • Track lot-to-lot consistency by keeping retained samples from each delivery.
  • Document every batch number with its test results so any future recall or customer complaint can be traced quickly.

Common buyer pitfalls: ordering powder grades for thin-wall PP parts (poor dispersion leads to drips during burning), ignoring moisture uptake during storage in humid climates, and mixing untreated powder directly in high-MFI PP where it fails to wet out. Specify masterbatch form plus surface treatment for reliable, repeatable flame-retardant performance.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们