服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Pressure-Sensitive adhesive / PVC Electrical Tapes: Fine-Particle Grades, Tack Interference and QC Checks

发布日期:2026-11-21 05:34:38   浏览量:0

Antimony trioxide (Sb2O3) masterbatch is specified in pressure-sensitive adhesive tapes and PVC electrical insulation tapes where halogen/Sb flame-retardant systems must coexist with adhesion and dielectric performance.

Why fine particle grades matter. In thin tape coatings (typically 20–50 µm dry film), coarse Sb2O3 particles create surface roughness, reduce optical clarity and act as stress concentrators that weaken peel strength. A D50 around 0.8–1.0 µm with a tight D97 ceiling (≤ 3–5 µm) minimizes particles larger than the coating thickness.

Tack and peel interference. High filler loading lowers tack by adsorbing on the adhesive matrix surface. Keep Sb2O3 in the 3–8 phr window (paired with brominated FR at roughly the 3:1 Br/Sb molar ratio) and verify a change in peel strength (e.g., 180° peel on stainless steel) of no more than 10–15% versus the unfilled control before approving a batch.

Dielectric considerations. For electrical tapes, moisture pickup and ionic impurities degrade insulation resistance; require CoA moisture < 0.3% and low lead/iron impurity limits.

Supplier QC checks. Confirm D50/D97 particle size distribution, Sb2O3 assay, whiteness consistency, and carrier resin compatibility with the adhesive system; run a small trial-coat validation before volume release.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们