服务热线
18971017202
Antimony trioxide (Sb2O3) masterbatch is a targeted additive in polymer systems used around mining infrastructure and heavy-duty cable management — cable tray covers, separator boards, insulation layers on trailing and industrial cables and halogen-free or halogenated compounds that must pass defined flammability ratings. The masterbatch route matters most where the pure powder form is not acceptable: polyamides, polyesters and other hydrolysis-sensitive resins, or systems where free-flowing feeding and dust control of the line are the priority.
Dry-run powder in a screw can degrade the anti-flame performance of the compound if the carrier and the processing window are mismatched. A masterbatch fixes this with a defined carrier resin and a controlled addition point. For glass-fibre charged polyamides, the masterbatch carrier must be the same viscosity class as the base resin, otherwise the fibre wet-out can suffer and impact properties drift downward. In polyesters and long-chain polyamide systems, moisture at dosing is a hidden quality problem: Sb2O3 itself is stable, but the additive stage must be dry enough not to trigger hydrolysis on the screw. Pre-drying of the masterbatch is therefore part of the purchase specification, not in-plant improvisation.
In halogenated formulations, the reference working window for the antimony-to-halogen ratio is around 1:3, adjusted by resin family, required rating, and total filler load. Where borates are used alongside, the ratio is re-tuned, not stacked: adding a second inorganic filler without correcting the antimony content is a common mistake that shows up only at the fire-lab stage. Trial mixtures are typically run at two levels — nominal and 10–15 percent over — because a slight overload rarely damages the resin, whereas under-addition shows up as a failing classification in the burn procedure. In polyamides and polyesters, the glass fibre content adds its own viscosity effect, so the antimony addition point and the screw temperature are re-qualified on the trial, never carried over from a powder-based recipe.
Agglomerates from poorly dispersed Sb2O3 create surface specks in filled polyamides and local weak points in thin-walled separator parts. High-shear screw configurations or a two-stage addition sequence reduces visible specks. In profile and sheet work, plate-out on the die is monitored as a run-indicator of overly fine material or an unsuitable carrier melt index: recording the time to first visible deposit and comparing it to a reference trial is a practical control. For surface-critical parts, whiteness consistency of the masterbatch is checked across batches, because tint drift in the final article is frequently traced to additive coloration, not to pigment lots.
Certificate of analysis review for a masterbatch grade goes beyond antimony content. The minimum set: declared antimony (tri-oxide-equivalent) and allowed moisture (commonly ≤0.3 percent), particle size distribution stated as D50 and D97 rather than an average alone, carrier resin identity and its melt-index window, and whiteness value. Batch traceability is verified by matching the batch number on the packaging to the CoA and the retained sample — an alignment that allows any post-delivery complaint to be documented to a specific production run. Where the supplier is qualified once and then ordered repeatedly, annual re-testing of D50/D97 and moisture against the agreed range keeps the formulation stable in both directions.
Small-scale trial before bulk supply, with the compound qualified on the customer's own line, remains the practical safeguard: dispersing behaviour in the actual resin cannot be fully predicted from the CoA alone.