服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for TPO Automotive Bumper Fascia: Dispersion, Paintability & CoA Checks

发布日期:2026-11-21 05:34:45   浏览量:0

Thermoplastic polyolefin (TPO) bumper fascias combine an olefinic matrix (PP/EPDM or TPV) with halogenated flame retardants. Antimony trioxide (Sb2O3) masterbatch is the synergist of choice here — but only if dispersion and surface quality are managed up front.

Key formulation guidance - Halogen-antimony ratio: Keep the Br/Sb ratio near 3:1. With decabromodiphenyl oxide (DBDPO) systems, retune Sb2O3 downward if borates (zinc borate) are added for smoke/afterglow — typically 15–20% of the antimony load can shift to ZB. - Carrier matching: Match masterbatch carrier MFI to the TPO grade so the pellet shears and disperses; mismatches leave fisheyes and agglomerates that show through paint. - Paintability & UV aging: High Sb2O3 loading raises surface roughness and can hurt paint adhesion and cause UV chalking. Keep total loading as low as the UL94 target allows, and check gloss retention after QUV-A exposure. - Low-volatility grade: For fascia (often painted), choose low-lead/low-iron, low-volatility Sb2O3 grades to avoid plate-out on tooling and discoloration in paint ovens.

Supplier qualification checklist (CoA) - Particle size: D50 0.8–1.5 µm, consistent D97 - Purity ≥ 99.5% Sb2O3, moisture < 0.3% - Whiteness consistent lot-to-lot (paint coverage tolerance) - Annual re-test + retained samples for a full paint-aging cycle

Process verification Run a trial panel: confirm UL94 rating, paint adhesion (cross-hatch), impact after weathering, and monitor die pressure/plate-out across a ≥30-minute run before releasing the grade to production.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们