服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 masterbatch for wood-plastic composite (WPC) decking profiles: carrier matching, dispersion in high-filler melt, fire-code and CoA qualification checks

发布日期:2026-11-21 05:34:45   浏览量:0

Application note for compounders and extrusion-line QC engineers specifying antimony trioxide (Sb2O3) masterbatch for flame-retardant WPC decking, railing and cladding profiles.

Carrier selection and melt flow. WPC extrusion runs at high wood-flour loading (50–65%) in a PE/PP matrix, so the masterbatch carrier must match the base resin and maintain flow with the filled melt. PE-based decking uses an LLDPE/LDPE carrier with MFI matched to the line's throughput; PP-based profiles use a PP carrier. A mismatched carrier raises apparent viscosity of an already viscous high-filler melt and drives die pressure up.

Dispersion in a high-filler system. Wood flour competes for wetting with mineral filler particles, so Sb2O3 agglomeration risk is higher than in neat polymer. Use a twin-screw side-feeder or pre-blend the masterbatch upstream of the vacuum vent; verify dispersion by ash-uniformity checks across the profile cross-section (sample head/middle/tail, ash spread should stay within 10% relative). Plate-out on die surfaces discolors the profile and signals overfine or poorly coated grades.

Fire-code dosing. Typical target for EN 13501-1 class B/C or ASTM E84 Class A claims: 3:1 halogen-to-Sb synergist ratio, with Sb2O3 dose adjusted once both halogen source (e.g. decabromodiphenyl ethane) and zinc borate (smoke suppression) levels are fixed; zinc borate partly substitutes Sb2O3 and the combined dose must be re-tuned from a single-variable lab curve rather than summed additively.

Supplier qualification items. Before first production run: CoA batch number matches the delivered lot; particle size graded for the die geometry (typical D50 0.8–1.5 μm, D97 under control); Sb2O3 assay consistent with spec; moisture <0.3% to avoid vent blooming; carrier MFI documented per batch; retained sample policy (12–24 months) agreed for dispute resolution. Re-verify each new lot with a small extrusion trial before releasing the full order to the line.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们