服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for PVC Electrical Insulation Tape: Dielectric & Print-Grade Control

发布日期:2026-11-21 05:34:59   浏览量:0

PVC electrical insulation tape remains one of the most demanding outlets for antimony trioxide masterbatch: the compound must hold stable dielectric performance while carrying a high halogen loading, and the surface must stay printable and tacky. Masterbatch form beats dry powder here.

Why Masterbatch Wins on Tape Lines

Dry Sb2O3 powder added at the calender or extruder drifts: feeder surging gives batch-to-batch variation you will see in dielectric breakdown spot tests. A PVC/EVA-carrier masterbatch with declared plasticizer content (tell your supplier your DOA/DINP ratio) pre-disperses the oxide, keeping the flame-retardant package uniform through thin gauge (0.13–0.19 mm) film.

Formulation Window

  • Halogen–antimony synergy: hold Cl:Sb molar ratio near 3:1 (chlorinated paraffin CP-52/70 + Sb2O3). Typical Sb2O3 contribution 4–6 phr on the polymer fraction.
  • Carrier MFI matching is irrelevant here — matched plasticizer compatibility matters. An under-plasticized carrier gives gel specks on calender rolls.
  • Use fine grades, D50 0.8–1.5 µm, to avoid white specks in 0.13 mm film and protect the print surface after corona treatment.

QC and Trials

  1. Dielectric strength per lot, tested on finished tape.
  2. Surface resistivity drift check.
  3. Unwind force / tack consistency — plate-out from poorly dispersed oxide raises surface friction.
  4. Print adhesion after 24 h.

Supplier Checklist

CoA per lot: Sb2O3 purity ≥ 99.5%, moisture < 0.3%, D50/D97 spread, Pb and Fe limits, whiteness value and consistency. Run an annual re-qualification and retain 200 g from each lot.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们